Metallized polymer coating, LONGMETAL, TIEFFE

Metallized polymer coating, LONGMETAL, TIEFFE

LONGMETAL is a wax-metallized self-polishing emulsion that guarantees strength and gloss by 30% more than the first-generation metallic wax, if you take care with a spray, it is better with polishing machines at high speed. Used also on bolted joints. AT VIEW - white liquid. COMPOSITION - emulsion of acrylic metallized polymers, wax emulsions in water, activating substances, leveling substances and stabilizers.

PH: 7 - 8

Instructions for use:
1. Wash the floor well with detergent, for example, AIR-85PN in the amount of 1-3%. Then rinse and leave to dry. To degrease or remove wax from floor coverings using floor cleaning machines, use DEWAX PLUS in a 2-5% ratio, after which you need to perform a mechanical suction and leave to dry.
2. On a perfectly dry flooring, apply a thin layer of LONGMETAL. Leave to dry and then apply a second small layer crosswise. 3. If desired, you can begin to burn-type polishing (wet effect), which can be done with a high-speed one machine of suit, you will need to apply at least three layers of the product.

CARE: Wet sweeping and / or washing with detergent. To restore the waste or lost gloss layer of wax with:

1. Use SUPRA-LI, diffusing type wax, as a 2-10% solution in water with a rag and a mop. This procedure is optimal for anti-slip flooring, because it does not “fill” the void.

2. SPRAY BUFFING: a procedure suitable for narrow or limited in use surfaces. Use the appropriate tool in the form of a spray or with a sprayer one low-speed action machine equipped with a red abrasive disc. Spray the product exactly in the right place, then several times hold one with the action machine until this place becomes dry and shiny.

Note: May freeze. The product should not be used to care for ceramics, hard leaded flooring and non-lacquered flooring wooden flooring.

Cautions: Check the information card for safety reasons.